Arb RD79 Manuale Utente Scaricare il pdf (Pagina 27)

4 Installing the Air System

4.3

Connection to the Bulkhead Fitting

 Trim the air line to length using a sharp knife.

 Insert the support spring over the end of the air line - small end first.

(Fig.18.)

 Insert the outer compression nut over the air line.

 Insert the 5mm [0.197”] ferrule over the end of the air line. Leave

approx. 5mm of tubing between the ferrule and the end of the tube.

Figure 18.

 Insert the support tube all the way into the end of the air line.

HINT : If the support tube is too difficult to insert, place the

end of the air line into a cup of boiled water to soften

the tubing.

 Insert the tube end all the way into the center compression nut.

 Screw on the outer compression nut and tighten. The ferrule and

support tube are now permanently attached.

 Assemble the support spring over the outside of the outer

compression nut.

 Secure any loose sections of tube with a cable tie.

1 2 ... 22 23 24 25 26 27 28 29 30 31 32 ... 35 36

Nessun commento

Arb RD79 Manuale Utente Pagina 27